![background image](http://html.mh-extra.com/html/intex/purespa-spj-h-20-1/purespa-spj-h-20-1_owners-manual_2081135012.webp)
250
A
S AVE THESE INSTRUCTIONS
(250IO) SPA (JET + HARD WATER) ENGLISH 7.5” X 10.3” PANTONE 295U 12/12/2014
English
Page 12
OPERATION
SPA CONTROL UNIT PANEL
On/Off Button:
Once the unit is plugged in, use this button to active the control unit panel
buttons. The light next to the button is green when activated. Press this button to turn off all
currently activated functions.
NOTE:
The On/Off button may appear as a black button in the center of the control panel.
Heat Button:
Use this button to activate the heating system. The pump will heat the spa
water until the water temperature reaches the set temperature. When the spa water
temperature drops 1-2°C (1.8-3.6°F) below the set temperature the heating system will restart.
When
the
fl
ame icon on the display is red, the heating system is activated. When the
fl
ame icon
turns green, the water is at the set temperature. The heating system is at rest and the
fi
ltration
system will continue working nonstop.
NOTE:
To stop the
fi
ltration system while the heater is at rest mode, press the
fl
ame button
fi
rst
and then the
fi
lter button. Pressing the
fl
ame button only while the heater is at rest mode will
turn off the heating system only and the
fi
ltration system will operate for another 24 hours before
it turns off automatically.
Celsius/Fahrenheit Toggle button:
The temperature can be displayed in either Fahrenheit or Celsius. The system’s default is
Celsius.
CAUTION:
NEVER use the spa if indicated water temperature is more than 40°C (104ºF).
Temperature Adjustment Buttons:
Pressing the Temperature Increase or Decrease
buttons will cause the LED to
fl
ash. When
fl
ashing you can adjust to the desired temperature
setting. If you hold these buttons down the values will rapidly increase or decrease. The new
and desired temperature setting will remain on the LED display for 5 seconds to con
fi
rm the new
value.
NOTE:
The default temperature is 20°C (68°F).
NOTE:
Temperature adjustment ranges from 20°C (68°F) to 40°C (104°F).
Water Filter Button:
This button turns the
fi
lter pump on and off. If the heating system is activated the
fi
ltration
system will automatically start.
The
water
fi
lter icon on the display is green when activated.
Water Jet Button:
Use this button to activate the jet massage system. After 30 minutes of
continues use, the jet massage system will automatically turn off. The water jet icon on the
displays is green when activated. The angle of the water jet nozzles inside the spa tub wall can
be adjusted manually.
WARNING:
Do not run jet system when the cover is attached, air pressure may accumulate
inside the spa and cause irreparable damage and bodily harm.
LED Display:
Once plugged in the LED displays the current water temperature automatically.
NOTE:
the built-in hard water treatment function works automatically in conjunction with the
fi
ltration system.
Jet Nozzle Adjustment
The amount of water and pressure coming out from the jet nozzles can be adjusted by
turning the jet nozzle rim clockwise (maximum water output), counterclockwise (low water
output) or anything in between. Closing one or 2 jet nozzles will divert more water pressure to
the other jet nozzles.
A: Heat Button
B: Celsius/Fahrenheit Toggle Button
C: Temperature Increase Button
D: Temperature Decrease Button
E: Water Filter Button
F: Water Jet Button
G: LED Display
H: On/Off Button
40
C
o
F
E
D
C
B
A
G
H
-
+