![background image](http://html.mh-extra.com/html/intex/purespa-sjb-hs-20-1g/purespa-sjb-hs-20-1g_owners-manual_2081131013.webp)
299
NLA
S AVE THESE INSTRUCTIONS
(299NL) SPA (JET + BUBBLE) ENGLISH 7.5” X 10.3” PANTONE 295U 08/07/2018
English
Page 13
SET UP (continued)
Spa Control Unit Installation
1.
Connect the spa control unit to the spa tub
(see drawing 9)
. Hand-tighten the connectors securely.
Do not use tools to tighten.
CAUTION:
Do not sit, lean, cover or place any objects over the spa control unit.
2.
Attach
the
fi lter cartridge housing assembly to the inside of the spa tub outlet grid (marked “B”)
(see
drawing
10)
.
Infl ate the spa tub fi rst before installing fi lter pump fi ttings.
3.
Before
fi lling with water ensure the bottom drain valve caps are securely closed on the inside and outside.
4.
Fill the spa tub with freshwater to a level between MIN and MAX marked on the inside of the spa wall. Do
not
over
fi ll the spa. Never move the spa tub with water inside and/or with the control base attached to the
spa as the spa or control base may be damaged.
WARNING:
Never pour water with a temperature higher than 40°C (104°F) into the spa
directly. It is recommended to fi ll the spa tub with lukewarm water for quick heating and
energy
saving.
5.
Place the spa cover and spa air bladder (pre-installed in spa cover) over the spa tub, and make sure the
spa cover buckles are locked using the key provided after pulling the buckled straps tight.
IMPORTANT:
Inspect the spa cover regularly for leak, premature wear and tear or deterioration. Never
use a damaged spa cover.
6.
Ensure the spa is plugged into an electrical socket and press the button to turn on the control unit
panel
buttons
fi rst. Press the button on the control panel to activate the heater, see “Spa Control Unit
Panel” operation section.
IMPORTANT:
The following conditions will lead to slow water heating:
• The ambient temperature is lower than 50ºF (10ºC).
• Outdoor wind speed is above 8-12 mph (3.5-5.4 m/s).
• The jet function is activated when heating the spa water.
• The spa is not properly covered with the spa cover when the water is heating.
Spa Cover
The attachment buckles of the cover are locking buckles. Two keys are provided in the plastic bag with the
manual and other accessories. Each buckle is marked with “locked” and “unlocked” symbols for easy operation:
put the key into the slot on the buckle and turn it to the appropriate position to lock or unlock the buckle
respectively.
To assure safety from unauthorized access, always put the cover on when spa is not in use and lock all
buckles. Always keep the keys out of reach of children. In case you misplace the keys, you can use any similar
size fl at screwdriver to lock or unlock the buckles.
When the spa is being used, the cover should be placed in a clean, dry area, otherwise it can pick up dirt and
bacteria. Covers should not be put on wooden tables or wooden decking because of the risk of bleaching the
wood. A cover lifter, dedicated support or similar device, is recommended for ensuring that the cover, mostly its
side facing the water, does not come into contact with the ground or any other dirty surfaces.
10
B
9