![background image](http://html.mh-extra.com/html/intex/purespa-sjb-hs-20-1g/purespa-sjb-hs-20-1g_owners-manual_2081131011.webp)
299
NLA
S AVE THESE INSTRUCTIONS
(299NL) SPA (JET + BUBBLE) ENGLISH 7.5” X 10.3” PANTONE 295U 08/07/2018
English
Page 11
SET UP (continued)
Infl ate the Spa Cover Air Bladder
1.
Open the infl ation valve and insert the infl ation hose
(7)
into the valve; press to infl ate until it is fi rm to the
touch but not hard
(see drawing 6)
.
2.
Disconnect the infl ation hose
(7)
from the air blower
infl ation outlet and the valve.
3.
Replace the control base infl ation cap
(9)
back; close and
recess the infl ation valve.
NOTE:
If there is a need to add some air to the spa tub wall or
spa cover air bladder after they have been setup, refer to above “Infl ate the Spa Tub Wall” and “Infl ate the
Spa Cover Air Bladder” sections. The cover air bladder is preinstalled inside the spa cover. If it needs to be
reinstalled, place the uninfl ated air bladder inside the spa cover lip before infl ating the bladder.
4.
Press the button to turn on the control unit panel
buttons fi rst. Press the button to infl ate the spa tub
wall for 8 to 10 minutes until it is fi rm to the touch but not
hard
(see drawing 5)
.
IMPORTANT:
Do not over infl ate or use high pressure air
compressor to infl ate.
5.
Press the button again to turn it off.
6.
Replace the air valve cap back.
NOTE:
The cap is designed to be screwed on and off.
Never exert force as this could cause the complete
internal infl ation system of the valve to come loose. See “Spa Tub Air Valve Fastening” for valve
maintenance.
6
7
5
Defl ation
For Spa Tub Wall:
1.
Unscrew the cap to reveal the stem, push the stem in
and turn 90 degree right to secure it in the down position
(see drawing 7)
.
2.
Once the defl ation is completed, push the stem in and
turn 90 degree left to return it to the infl ation position.
3.
Replace the cap back.
NOTE:
To defl ate the spa tub for storage, see “STORAGE”
section.
For Cover Air Bladder:
1.
Pull valve cap out and squeeze the valve at its base until defl ated.
2.
Close and recess the valve back.
7
4
7
1
2
3
9
24
2.
Unscrew the control base infl ation cap
(9)
to reveal the air blower infl ation outlet, insert one end of the
infl ation hose
(7)
into the outlet and turn to the right to lock it
(see drawing 3)
.
3.
Unscrew the air valve cap to reveal the stem in the up position for infl ation. Insert the other end of the
infl ation hose
(7)
into the valve and turn to the right to lock it in position
(see drawing 4)
.