(187PO) MODEL ZS8110 OZONE & SALTWATER SYSTEM ENGLISH 7.5” X 10.3” PANTONE 295U 06/28/2013
187
PO
SAVE THESE INSTRUCTIONS
English
Page 20
TROUBLESHOOTING GUIDE
INSUFFICIENT
CHLORINE
WHITE FLAKES IN
THE WATER
NO LED DISPLAY
•
Insufficient operating hours of
the Ozone & Saltwater System.
•
The salt level in the pool water
is less than 2000ppm. This is
insufficient.
•
Chlorine loss due to intense
sunlight
exposure.
•
The bather load has increased.
•
Clogged or dirty electrolytic cell.
•
High UV level exposure.
•
Excessive calcium hardness is
present in pool water.
•
No power supply.
• RCD/GFCI has not reseted.
•
A power fuse has blown.
•
LED failure.
•
Increase the daily Ozone & Saltwater System
operating time. See “Operating Instructions”.
•
Check the salt level with the Test Kit. Adjust as
needed. See “Salt & Pool Water Volumes”.
•
Add appropriate stabilizer. See “Cyanuric Acid
table”.
•
Use a pool cover when the pool is not in use and/
or when the unit is operating.
•
Increase the daily Ozone & Saltwater System
operating time. See “Operating Instructions”.
•
Remove the cell for inspection, clean it if necessary.
See
“Maintenance”.
•
Cover the pool with a pool cover for 2 days
with the device running and then test the
water using the test strips.
•
If the pool is clean and clear, add stabilizer to the
water and then test the water with the device running.
•
Drain about 20 to 25% of the pool water and
add fresh water to decrease the calcium
hardness. Inspect the electrolytic cell for
scale buildup. Clean the electrolytic cell if
necessary.
•
Plug the cell cord firmly into the cell housing
receptacle.
•
Find out the switch and turn on.
•
Reset the RCD/GFCI.
•
Contact Intex Service Center.
PROBLEM CAUSE SOLUTION
IMPORTANT
If you continue to experience difficulty, please contact our Consumer Service
Department for assistance. See separate “Authorized Service Centers” sheet.
Operation is subject to the following two conditions:
(1)
this device may not cause interference, and
(2)
this device must accept any interference, including interference that may cause undesired operation
of the device.
Changes or modifications not expressly approved by the party responsible for compliance could void
the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and the receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
•
Consult the dealer or an experienced radio/TV technician for help.
