InterTest, Inc. • 908-496-8008
MZ-5 FS™ Inspection System
EM15201 Rev A
Page
30
Version 1.0 • Nov 2020
Angle
a) You need to click on the screen three times to form the points of the angle
i) Once the angle is placed. You can move the end points. Hover over the point. The cursor
will change to an Arrow.
ii) The position of the line can be altered. Hover over the line, cursor will change to a hand
with the index finger extended. You can now reposition the line.
Figure 35 Angle Measurement
Angle # & Measured Value
