www.intertec.info
Operating Instructions CP MICROTHERM DBNA
Page 8 / 8
HOM146708235Ien-4
INTERTEC-Hess GmbH · Raffineriestr. 8 · 93333 Neustadt/Donau · Germany ·
+49 9445 9532-0 · [email protected]
• Sort other components according to their material
properties and dispose of them.
NOTICE
Environmental damage may be caused if dis-
posed of incorrectly!
Electrical scrap and electronics components are subject
to hazardous waste treatment and must only be dis-
posed of by certified specialists!
The local community authorities or specialist waste dis-
posal companies can provide information on environ-
mentally friendly disposal.
15
Certificate of Conformity
The manufacturer, INTERTEC-Hess GmbH, Raffiner-
iestrasse 8, 93333 Neustadt/Donau, Germany, hereby
declares in sole responsibility that the product
Product / Type designation:
CP MICROTHERM
complies with the provisions of the following directives
INMETRO No. 179, of May 18th, 2010 complies with the
following standards, harmonized standards, where ap-
propriate and/or standardized documents:
ABNT NBR IEC 60079-0:2013 Versão Corrigida 2: 2016
ABNT NBR IEC 60079-1:2016
ABNT NBR IEC 60079-31:2014
ABNT NBR IEC 60529:2005 Versão Corrigida 2:2011
IEC 61000-6-4:2007+A1:2011
Designation:
NCC 17.0136 X
Ex tb IIIC T80°C....T200°C
Ex db IIC T6, T5, T4, T3 IP66/IP68
Neustadt, June 25th, 2018
Dipl.-Ing. Martin Hess, Managing Director
16
Further information and service
If the information contained in this instruction manual
should not be sufficient in any way, then INTERTEC
would be glad to be at your disposal to provide further in-
formation and service.
Please contact your INTERTEC contact person or dir-
ectly contact
INTERTEC-Hess GmbH
Raffineriestr. 8
93333 Neustadt/Donau
Germany
Phone: +49 9445 9532-0
e-mail: [email protected]
Website: www.intertec.info
Warranty
The legally defined warranties and warranty periods of
24 months are applicable to our scope of supply and ser-
vices.
You will find more detailed information in the manufac-
turer warranty from INTERTEC for heating systems and
accessories.
These instructions do not claim to take all
designs, options or changes into consid-
eration, even in association with installa-
tion, operation or maintenance. INTER-
TEC does not accept responsibility for
providing information about changes
made retrospectively.
