Interroll RollerDrive EC200, User Manual

Page: 14 / 32

12 Version 1.0 (11/2007) en
Original language
Product information
RollerDrive EC200
Speed settings
If you do not use the recommended DriveControl ( see "DriveControls for the
RollerDrive EC200", page 10 ), you may change the speed of the RollerDrive
EC200 by altering the voltage on pin 5 of the motor plug.
Input voltage of Pin 5 at motor plug is not polarity-
proof
Damage to the RollerDrive
¾
Ensure the correct polarity.
$QDORJYROWDJHVHWWLQJRQSLQRIPRWRUSOXJ>9'&@
6SHHG3HUFHQWDJH>@
Hint
In the hatched area the RollerDrive does not run within the specified tolerance of
± 5 %.
Rotary switch
speed setting at
DriveControl Voltage setting
on pin 5
[VDC] Speed of transport [m/s (ft/min)] ± 5 %
Gear ratio
12:1 Gear ratio
16:1 Gear ratio
36:1 Gear ratio
48:1 Gear ratio
64:1
0/8
5 to 24
0.98 (192.7) 0.74 (145.6) 0.33 (64.2) 0.25 (49.2) 0.18 (36.1)
1/9 0.98 (192.7) 0.74 (145.6) 0.33 (64.2) 0.25 (49.2) 0.18 (36.1)
2/A 4 0.75 (147.2) 0.56 (110.4) 0.25 (49.1) 0.19 (36.8) 0.14 (27.6)
3/B 3.75 0.56 (110.4) 0.42 (82.8) 0.19 (36.8) 0.14 (27.6) 0.11 (20.7)
4/C 3.30 0.41 (80.1) 0.31 (60.1) 0.14 (26.7) 0.10 (20.0) 0.08 (15.0)
5/D 2.93 0.30 (58.5) 0.22 (43.8) 0.10 (19.5) 0.07 (14.6) 0.06 (11.0)
6/E 2.68 0.21 (41.1) 0.16 (30.9) 0.07 (13.7) 0.05 (10.3) 0.04 (7.7)
7/F 2.44 0.14 (28.1) 0.11 (21.1) 0.05 (9.4) 0.04 (7.0) 0.03 (5.3)