Version 2.0 (12/2019) Online
Translation of the original operating manual
31 von 38
Troubleshooting
8
Troubleshooting
8.1
Troubleshooting
Symptom
Possible Cause
Help
AdControl is not working or is
working incorrectly
No power supply
¾
Check whether the output
voltage of the power supply
is within the specified voltage
range.
¾
Check the connections and
correct if necessary.
RollerDrive is rotating at the
wrong speed
Wrong position of the DIP switches
¾
Check and if necessary
correct the position of the DIP
switches (see „DIP switches”,
page 19).
AdControl faulty or damaged
¾
Replace the AdControl.
Maximum speed not reached
Improper gear reduction of the
RollerDrive EC310
¾
Use the RollerDrive EC310
with the appropriate gear
reduction.
The error signal is active in the event of the following faults:
• RollerDrive error
• RollerDrive not connected properly
• Upper and lower levels of permitted operating voltage transgressed
• Operating voltage has reverse polarity
• Chopper resistor overheating
