5640015_07.17_EN
PORTABLE IMILK401
-
Instruction Manual, Operation and
Maintenance original instructions
THIS MANUAL IS THE PROPERTY OF -
InterPuls
S.p.A.
-
ANY COPYING, EVEN PARTIAL, IS STRICTLY PROHIBITED
MI - 40
7.6 Washing
To go into WASHING mode, press keys
and
simultaneously to start the washing phase from
detachment. The display will monitor and display the washing water temperature.
CAUTION
For proper maintenance of the flow sensor, it is recommended to carry out at least 2 acid
washes a week with hot water (at least 60°C
– 140°F). Failure to comply with this warning may
cause system reading errors.
If provided, data download onto the PC by means of the DHM software occurs during the washing phase.
The following screen appears on the panel that is currently downloading data, which shows the advance
process.
CAUTION
During data download:
-
Do NOT operate any panel keys.
-
Do NOT remove Combifast from the panel in question.
-
Do NOT insert or remove other Combifast on the washing station.
You are advised to connect all Combifast in their proper washing stations with the fixed parts
NOT powered. Once all panels are connected, power the fixed stations to start data
download.
8 PROGRAMMING
The Portable iMilk401 can set up to 5 programs (P1
– P3 – P5 – P7 – P9); each one can be customised with
different parameters and features.
P1
P3
P5
P7
P9
MILKING
Present
Present
Present
Present
Present
LEVEL
X
Present
Present
Present
Present
STIMULATION
X
X
X
X
Present
Programs P3, P5 and P7 differ on account of their different general parameter settings. For details, refer to
the following paragraph, which has a complete list of programming parameters.
During the detachment phase, the display indicates the program currently being used in the top left corner,
and you can press the
key to go to the next program (in order to do so, the
Lock Programs
parameter
must be deactivated).
Water
temperature