Interphase ENTIA 5536 DM PRI, User Manual

Page: 114 / 244

Setting Up or Removing Channels as RAS Ports
94
Interphase Corporation
Removing RAS Port Designations
If you need to remove a channel from the RAS device list, do
the following:
1. Access the Remote Access Setup dialog box, as
described in Steps
1 through 3 of Setting Up RAS Port
Designations on page 90 .
2. Select the channel in the list on the Remote Access
Setup dialog box, and click
Remove .
3. When you have finished removing RAS ports, on the
Remote Access Setup dialog box, click
Continue .
The Network Services dialog box appears.
4. T
o make the settings take effect,
click Close .
A message informs you that you must shut down and
restart your computer before the settings take effect.
5. Continue as follows:
– If the system is a basic Windows NT system, without
the Windows NT Service Pack installed, click
Yes to
restart the computer.
– If the Windows NT Service Pack is installed, click
No . Then reinstall the Service Pack. (Service Pack 3
or higher is recommended.) Restart the system when
prompted after you complete the Service Pack
installation.