Hardware Management
82
Interphase Corporation
If you change to a switch type that uses fewer ISDN B
channels, you must remove unused ISDN and digital modem
RAS ports after saving WAN setup changes. If you change to
a switch type that uses more ISDN B channels, you must add
ISDN and digital modem RAS ports after saving changes. This
is because the number of ISDN B channels available as RAS
ports differs in different locations (23 in North America and
Japan; 30 in Europe and Australia). See
Removing Channels as RAS Ports
for instructions.
Editing DS1 Properties
DS1 properties include the CRC type and the CSU properties.
On the ISDN PRI Port Properties dialog box (shown in
Edit DS1 Properties
.
The DS1 Properties dialog box appears:
Summary of Contents for ENTIA 5536 DM PRI
