14
In the window that opens, press the “Change…” button, then chose a drive letter and
hit “OK”.
IMPORTANT:
Use the Write Filter to commit you
r changes when you’re done. See
The Write Filter on page 5
Run ViewCommander, and make this the
‘default archive drive’ in the
System
Settings
.
Factory Reset
To reset the ViewCommander-Edge unit back to its factory settings, connect a video
monitor and keyboard to the Edge and power up the device.
Click the restore option during the 5-second boot-up windows that displays before the
booting of Windows.
Wait a few seconds until you see the command prompt.
Type “restore” at the command prompt.
Type ‘exit’ when you see the command prompt again and wait for the Edge to reboot
and re-configure itself.
ViewCommander Edge will have the same settings (IP address, password, etc..) as
when it shipped.
ViewCommander specific settings should remain intact.
Summary of Contents for ViewCommander-Edge 2511
Page 12: ...12 And login when prompted...
