Page 10
AIR CONDITIONER USE
----------------------------------------------------------------------------------------------------------------------------------
Cool Mode Feature
Use the Cool mode at Low, Med, High or Auto Fan
Speed for cooling. Use the Temperature Increase
/Decrease pads to set the desired temperature between
64°F and 86°F in 1°F increments.
The display will indicate the set temperature in the cool
mode. An electronic thermostat is used to maintain the
room temperature. The compressor will cycle on and off
to keep the room at the set level of comfort. Set the
thermostat at a lower number and the indoor air will
become cooler. Set the thermostat at a higher number
and the indoor air will become warmer.
NOTE:
If the air conditioner is off and is then turned on while set
to a Cool setting or if turned from a fan setting to a Cool
setting, it may take approximately 3 minutes for the
compressor to start and cooling to begin.
Cooling Descriptions
For Normal Cooling—Select the Cool mode - Low or
Med fan speed - Select a normal cooling temperature.
For Maximum Cooling—Select the Cool mode - High
fan speed - Select a lower set temperature if necessary.
For Quieter and Nighttime Cooling—Select the Cool
mode - Low fan - Select a comfortable set temperature.
----------------------------------------------------------------------------------------------------------------------------------
Heat Mode Feature
Use the Heat mode at Low, Med, High or Auto Fan
Speed for heating. Use the Temperature Increase
/Decrease pads to set the desired temperature
between 64°F and 86°F in 1°F increments.
The display will indicate the set temperature in the heat
mode. Your window unit is heat pump with auxiliary
electric heating. Unit will select compressor operation
or electric heater depending on the difference between
room temperature and ambient temperature. The heat
pump and electric heater will not operate at the
same time.
NOTE:
Do not try to operate your air conditioner in the heating
ode when outside temperature is above 86°F, the
inside evaporator coil will freeze up.
When the outdoor temperature is below 55°F the
electric heat will be activated and the compressor will
turn off.
----------------------------------------------------------------------------------------------------------------------------------
Fan Only Mode Feature
Use the Fan Only Mode at Low, Med or High fan speed
to provide air circulation and filtering without cooling.
Since fan-only settings do not provide cooling, a Set
Temperature cannot be entered. The room temperature
will appear in the display.
NOTE: Auto Fan Speed cannot be used when in the Fan
Only Mode.
----------------------------------------------------------------------------------------------------------------------------------
Energy Saver Mode Feature – Cooling Only
The energy saver mode operates the cooling system
only.
ON – The will cycle on and off with the compressor.
This may result in wider variations of room temperature
and humidity.
OFF – The fan operates continuously as the
compressor cycles on and off.
NOTE: The fan may continue to run for a short time
after the compressor cycles off.
----------------------------------------------------------------------------------------------------------------------------------
