background image

P/N 064216-004

TRAKKER Antares Battery Pack Instruction Sheet

The TRAKKER

®

 Antares

 lithium-ion battery pack is designed for use in your

TRAKKER Antares 2420 or 2425 hand-held terminal and must be recharged using the
TRAKKER Antares TZ2400 Battery Charger.

Before using the battery pack, please read this instruction sheet thoroughly and retain it
for future reference.

Charging the Battery Pack

 

You must fully charge your battery pack prior to using it in your TRAKKER
Antares 2420 or 2425 terminal.

 

Usually a battery pack is fully charged in less than three hours.

 

Remove the battery pack from the charger within 24 hours after charging is
complete.

 

Battery packs can be charged after partial discharge without affecting the original
battery capacity.

Note: Although the Intermec battery pack looks similar to commercially available
video camera battery packs, it 
will not fit in other battery chargers.

Caution
Use only the Intermec TZ2400 Battery Charger to recharge the Intermec battery pack
(P/N 063278 or 068537). Recharging this battery pack with any other charger could
result in damage to the battery pack.

Conseil
Utiliser seulement le chargeur de batterie Intermec TZ2400 pour recharger la
batterie Intermec (n° 063278 ou 068537). Ne pas recharger cette batterie avec un
autre type de chargeur car cela risque d’endommager la batterie.

Installing the Battery Pack

Before installing the Intermec-labeled battery pack (P/N 063278 or 068537), make sure
you remove the rubber bumper from the terminal
battery door. The terminal battery door will not close
if the bumper is on the door after the battery pack is
installed.

Note: If you are using a Sony-labeled battery pack,
make sure the rubber bumper is installed over the
ridge near the wall on the terminal battery door. The
rubber bumper on the terminal battery door keeps
the battery pack in place.

Rubber bumper

TRAKKER Antares 
terminal battery door

242XI.011

Reviews: