Chapter 2 — Installing the Forklift Power Supply
18
Forklift Power Supply Installation Guide
2
Use the heat gun to shrink tubing.
3
Wrap the 1/8-inch shrink sleeve tubing (P/N 321-650-003)
over shield wire.
Preparing the Cable Ends
Use these instructions to prepare the cable ends.
To prepare the cable ends
1
Strip 0.6 cm (.25 inch) of insulation from individual wires.
2
Crimp a terminal ring (P/N 809-083-009) onto the white-
green twisted pair (negative) of wires.
3
Crimp one end of the fuse holder assembly
(P/N 315-075-0013) on the red-black twisted pair (positive).
4
Position short lengths of heat shrink tubing as shown in Step
2. Crimp the other end of the fuse holder assembly to the
twisted pair of wires and then attach then a terminal ring
(P/N 809-083-009) on to it.
Note
: Be sure to shield wire to the metal surface on which the
power supply is mounted.
Note:
All crimps should be checked to ensure the wire is
completely captured in the terminal ring or fuse holder. Loose
connections will fail.
1/8”
3/8”
3/8”
3/8”
Shield wire
Green and white twisted pair
Red and black twisted pair
Fuse holder assembly
