ELECTRICAL REQUIREMENTS
A qualified electrician should complete all required wiring. Models WL100HPS & WL100MH will accept 120, 208, 240
or 277 Volts AC. Models WL100HPST & WL100MHT will accept 120, 277 or 347 Volts AC. Fixtures must be properly
grounded for safety. A mounting suitable for outdoor use and rated for wet locations is required. Follow all applicable
electrical codes and regulations.
7.48in.
(190m m )
8.86in.
(225m m )
8.46in.
(215m m )
Mounting
Plate
Locknut Inside Fixture
HID Wall Pack - WL Series
INSTALLATION INSTRUCTIONS
Models: WL100HPS, WL100HPST,
WL100MH, WL100MHT
FOR OUTDOOR USE ONLY
NOT FOR USE IN HAZARDOUS
ATMOSPHERES
IMPORTANT: Read instruction sheet
carefully before installing fixture. Retain
instructions for future reference.
Please see below for list of warnings.
WARNING
Electric shock hazard
Disconnect power at circuit breaker or fuse box before
installing or servicing light.
WARNING
Fire hazard
USE MIN 60°C SUPPLY CONDUCTORS. CONNECT TO
SUPPLY IN EXTERNAL JUNCTION BOX ONLY.
Lamp and housing become very hot during use. Ensure free
air circulation around unit to dissipate heat. Avoid enclosed
locations and locations where flammable debris (leaves, cut
grass, etc.) might collect. Avoid locations where humans or
animals might accidentally touch fixture.
WARNING
Explosion hazard
Never operate light without securing the lens door. When
light is operating, the gas in the lamp inner arc tube is at
high pressure. Never operate light if the fixture lens or outer
glass envelope of the lamp is broken or missing.
WARNING
Explosion hazard
Wear safety glasses and gloves when handling lamp, High
Pressure Sodium outer envelope is under vacuum and
could implode. Metal Halide outer envelope is pressurized
and could explode if broken.
WARNING
UV hazard
(Metal Halide Lamps Only)
The type of lamp used in this fixture can cause serious
skin burn and eye inflammation from short wave ultra
violet radiation if outer envelope of the lamp is broken or
punctured, and the arc tube continues to operate. Do not
use where people will remain for more than a few minutes.
Certain types of lamps that will automatically extinguish
when the outer envelope is broken or punctured are
commercially available.
WARNING
Figure 1
Mount Fixture horizontal
Screws
Lens
Cover
Screws
MOUNTING & WIRING
Loosen (4) screws, open, and remove fixture lens cover.
Set lens cover aside to prevent damage while installing.
(See Figure 1)
Loosen (2) screws and remove reflector.
Remove locknut from mounting plate threaded nipple inside
fixture. Separate mounting plate from fixture.
Apply provided gasket to back of mounting plate for sealing
against junction box.
Identify supply voltage.
6. Select appropriate fixture wire to match incoming voltage.
Models WL100HPS & WL100MH are shipped with 277 V wire
ready for connection. Models WL100HPST & WL100MHT
are shipped with 347 V wire ready for connection. If supply
voltage is lower, cap wire marked 277 V (or 347 V for tri-tap
models) with appropriate twist on wire connector and strip
fixture wire marked with matching voltage. (See Figure 2
through Figure 5)
1.
2.
3.
4.
5.
Lamp Types:
High Pressure Sodium 100 Watt
High Pressure Sodium 100 Watt with Tri-Tap
Metal Halide 100 Watt
Metal Halide 100 Watt with Tri-Tap
