Intermatic GRASSLIN talis II PHB 360-20-1i, Operating Instructions Manual, Page: 7 / 36

EN
7
Safety
Risk of fatal electric shock!
Only allow a qualified electrician to
install and connect the device.
WARNING!
• Before installing the product, disconnect the
mains voltage!
• Before installation, a type C circuit breaker
(250 VAC, 10 A) should be installed, in accord-
ance with EN60898-1.
• When lamps from some manufacturers burn
out, they can cause a high inrush current,
which can permanently damage the detector.
• Observe the national regulations and safety
conditions.
• Interventions in and modifications to the device
shall result in loss of warranty and guarantee.
Read and observe this manual in order to ensure
trouble-free functioning of the device and safe
work.
For more information:
http://qrc.graesslin.de/801015287
Information about the device
Description of the device
The presence detector operates on the principle of
passive infra-red sensors (PIR sensor). It automat-
ically regulates the connected loads according to
whether persons are present (movement detection)
and according to the ambient brightness. The built-in
light sensor continuously measures the strength of
daylight and the system compares this against the
set lux value.
• The light remains switched on for as long
as movement and insufficient daylight are
detected.
• After the last movement is detected, the lighting
remains switched on for the set run-on time.
• The lighting switches off automatically as soon
as sufficient ambient brightness is reached,
even if movement is detected during this time.
• The presence detector is suitable for use in
indoor spaces.
Technical data
Supply voltage 230 V~ ±10% 50/60 Hz
Detection range 360°
Range approx. Ø 20 m (Fig. 6)
Time setting approx. 30 sec. – 30 min.;
TIME
Test 1s
5m
5s
15m
30m
LUX
10
100
300
2000
METER
; test
Light value
approx. 10 lux – “ ”;
“ ” = learning mode
Ambient temperature -20 °C to +45 °C
Protection class II
IP code IP20
IP54 for on-wall mounting
Energy consumption < 1 W (in standby mode)
Operating manual
talis II PHB 360-20-1i – presence detector