MOUNTING & WIRING
Screw the threaded mounting arm of the fixture into 1/2” NPS
mounting hole on mounting device.
Using provided twist on or other approved connectors,
connect the fixture wires to the supply wires as follows: (See
Figure 3 or Figure 4)
Identify supply voltage.
Open lens door and remove reflector.
1.
2.
a.
b.
Figure 1
9.92in.
(252mm)
6.93in.
(176mm)
10.5in.
(267mm)
14.6in.
(370mm)
Mounting
Arm Bolt
Locknut
Figure 2 (
Install with Lamp vertical)
Lens
Door
Screw
Reflector
Screw
Lampholder
HID Flood Light - FL Series
INSTALLATION INSTRUCTIONS
Model: FL150MH, FL175MH,
FL150MHT & FL175MHT
9.92in.
(252mm)
6.93in.
(176mm)
10.5in.
(267mm)
14.6in.
(370mm)
FOR OUTDOOR USE ONLY
NOT FOR USE IN HAZARDOUS
ATMOSPHERES
IMPORTANT: Read instruction sheet
carefully before installing fixture. Retain
instructions for future reference.
ELECTRICAL REQUIREMENTS
A qualified electrician should complete all required wiring. Models FL150MH & FL175MH will accept 120, 208, 240 or 277
Volts AC. Models FL150MHT & FL175MHT will accept 120, 277 or 347 Volts AC. Fixtures must be properly grounded for
safety. A mounting suitable for outdoor use and rated for wet locations is required. Follow all applicable electrical codes
and regulations.
Please see below for list of warnings.
WARNING
Electric shock hazard
Disconnect power at circuit breaker or fuse box before
installing or servicing light.
WARNING
Fire hazard
USE MIN 60°C SUPPLY CONDUCTORS. CONNECT TO
SUPPLY IN EXTERNAL JUNCTION BOX ONLY.
Lamp and housing become very hot during use. Ensure
free air circulation around unit to dissipate heat. Avoid
enclosed locations and locations where flammable debris
(leaves, cut grass, etc.) might collect. Avoid locations
where humans or animals might accidentally touch fixture.
WARNING
Explosion hazard
Never operate light without securing the lens door. When
light is operating, the gas in the lamp inner arc tube is at
high pressure. Never operate light if the fixture lens or
outer glass envelope of the lamp is broken or missing.
WARNING
Explosion hazard
Wear safety glasses and gloves when handling lamp.
Metal Halide outer envelope is pressurized and could
explode if broken.
WARNING
UV hazard
(Metal Halide Lamps Only)
The type of lamp used in this fixture can cause serious
skin burn and eye inflammation from short wave ultra
violet radiation if outer envelope of the lamp is broken or
punctured, and the arc tube continues to operate. Do not
use where people will remain for more than a few minutes.
Certain types of lamps that will automatically extinguish
when the outer envelope is broken or punctured are
commercially available.
WARNING
Lamp Types:
Metal Halide 150 Watt & 175 Watt
Metal Halide 150 Watt & 175 Watt with Tri-Tap
