P/N 466-
5247 • REV A • 25APR16 © 2016 United Technologies Corporation. All rights reserved.
Installation Sheet
Enrolling
Each keyfob is learned in to a control panel as an unsupervised sensor and uses one available zone slot. For
all Concord, Simon3 and Simon XT panels, use sensor group number 01, 03, 06 or 07. Please refer to your
specific control panel installation manual for full instructions.
Operation
Panic or Aux
If the keyfob is programmed using a panic or portable auxiliary group number, pressing the Lock and Unlock
buttons simultaneously will activate an audible or silent alarm (depending on group number) and initiate reports to
the central station.
Replacing the Battery
Because keyfobs are non-supervised devices, a low battery signal will only be received by the control panel when
the device is within range of the receiver and a button is pressed (if the device is not in use, no low battery signal
will be sent until a button is pressed). When the device is carried beyond the range of the receiver and/or is seldom
used/tested, the battery could wholly deplete without a warning of the battery condition being sent to the panel. If
the LED on the device appears dim or does not turn on when a button is pressed, it is a warning that the battery
may be low or depleted and should be replaced. To ensure proper functionality, test the device weekly and follow
these simple steps to replace the battery when necessary:
1. With a key or small screwdriver, press the black tab located at the bottom of the remote (fig.1) and slide the
chrome trim off.
2. Carefully separate the front and back piece of plastic to reveal the battery.
3. Replace with a CR2032 battery ensuring the + side of the battery faces up (fig.2).
4. Re-assemble the plastics and ensure they click together
5. Ensure the notch in the chrome trim is aligned with the back of the plastic. It will only go on one way (fig. 3).
Lock
Depending on your control panel:
Press once to arm in Stay mode.
Press twice to arm in Away mode.
Press three times to activate the latchkey feature.
Unlock
Press this button to disarm your system. You do
not have to enter your access code when you
use this key to disarm the system.
Light
For NetworX panels, press this button to arm the
system in Stay mode. For Concord, Simon 3 or XT it will
turn system controlled lights on or off.
Star
The star button function depends on the
individual panel programming. Refer to the
installation instructions for your panel.
Figure 1
Figure 2
Figure 3
TX-E101 Four Button Chrome Wireless Keyfob
