© 2018 United Technologies Corporation. All rights reserved.
P/N 1073435-EN
• REV
B
• ISS
15MAY18
Interlogix is part of UTC Climate, Controls & Security, a unit of United Technologies Corporation.
TVP
-CBB
Compact PTZ Back Box Installation
Instructions
Specifications
Dimensions
:
157.73 × 39.73 mm (6.21 × 1.56 in.)
Metal adapter plate
(included with the PTZ)
, 1 cable gland
(located on the side of the back box), and 1 plug (located
on the base of the back box) are included.
Weight:
450 g (0.99 lbs.)
Accessories
:
Drill template: 1 pcs
Drywall anchor
s: 4 pcs
Used to install the
back box
to the
mounting surface
.
Screw A: 4 pcs
Used to install the
back box
to the
mounting surface
.
Screw B: 4 pcs
Used to install the metal adapter plate to the
back box
.
Supported cameras
The compact PTZ camera
back box
can be used with following
cameras:
IP Compact
PTZ Camera:
TVP
-5103
Installation
The PTZ was not designed to be mounted to a wall. It should
be mounted to a ceiling. The bubble assembly should be
pointing towards the ground
.
To install the TVP-5103 PTZ camera on a ceiling using the
TVP-CBB:
1.
Using the Torx wrench that is supplied with the PTZ,
loosen the locking screw at the base of the PTZ. Loosen
slightly the three screws/standoffs on the base of the PTZ
camera and rotate the metal adapter plate
counterclockwise to separate it from the PTZ camera
.
Open
2.
Prior to drilling the mounting holes, decide where the
interconnect cable access is to be located. If exiting
the
side of the back box, positioning the back box may vary.
Align the cable access/cable gland in the desired direction.
If the interconnect cables will be exiting the bottom of the
back box, also provide a hole in the mounting surface for
cable exit
.
