14 IFS MC250-4T/XXX Series User Manual
Troubleshooting
This chapter contains information to help you solve issues. If
the Industrial Fast Ethernet Switch is not functioning properly,
make sure the Industrial Fast Ethernet Switch was set up
according to instructions in this manual.
The Link LED is not lit
Solution:
Check the cable connection of the Industrial Fast Ethernet
Switch.
Performance is bad
Solution:
Check the speed duplex mode of the partner device. The
Industrial Fast Ethernet Switch is operating at Auto-negotiation
mode by default and if the partner is set to half duplex, then
the performance will become bad.
Link LED is light, but the traffic is irregular
Solution:
Check that the attached device is not set to dedicate full
duplex. Some devices use a physical or software switch to
change duplex modes. Auto-negotiation may not recognize
this type of full-duplex setting.
Why does the Industrial Fast Ethernet Switch not connect
to the network?
Solution:
Check every port LED on the Industrial Fast Ethernet Switch.
Try another port on the Industrial Fast Ethernet Switch to
make sure the cable is installed properly while make sure the
cable is the right type
Turn off the power and turn on the power again after a while.
