Interactive Technologies SceneStation, User Manual, Page: 71 / 96

SceneStation Installation and Programming Guide Using the Programmer's Remote | 65
962: Enter Self-Test Mode
When this option is selected, the station enters its “Self Test Mode”.
See the Self Test Mode appendix for details.
981: Recall Built-In Show 1
When this option is chosen, the station’s memory is erased and a built-in show is loaded into
memory. “Show 1” is a test show that has each preset programmed with a single DMX channel
set to 100%. Preset 1 has Channel 1 at 100%. Preset 2 has Channel 2 at 100%, etc.
This operation cannot be undone.
982: Recall Built-In Show 2
When this option is chosen, the station’s memory is erased and a built-in show is loaded into
memory. “Show 2” is a demonstration show that is set up for running RGB LED fixtures. Each
button on the station has a different behavior.
This operation cannot be undone.
989: Erase Memory
When this option is chosen, the station’s memory is erased and the station is returned to its
“Factory Default” state.
This operation cannot be undone.