Interactive Technologies SceneStation, User Manual, Page: 62 / 96

56 | Using the Programmer's Remote SceneStation Installation and Programming Guide
Edit Loop to Preset
Normally, when stepping from preset to preset (either manually with a Sequential
button or automatically with a follow time), presets step in numerical order (such as
1, 2, 3, 4, 5, etc.).
The Loop To Preset property allows a preset to specify that a different preset should
come after this one.
Press the
LOOP button to switch to the Loop to Preset mode. The center LED on
the station will blink Green (the same color as the Scene button on the remote).
Then, press the number of the preset you want this preset to loop to.
For example, to create a short loop that causes presets to execute in the order 1, 2, 3, 4, 1, 2,
3, 4, 1, 2, 3, 4, etc., then preset 4 should have a Loop back to preset 1. While editing preset 4,
press:
LOOP + 1
To remove a loop from a preset, enter zero (0). For example:
LOOP + 0
When finished setting the Loop property of a preset, you can either press ENTER to save the
changes and return to the station’s Idle Mode, or you can press a different property button (Fade,
Follow, Loop, Repeat, etc.) to enter the value of another property.