Interactive Technologies SceneStation, User Manual, Page: 61 / 96

SceneStation Installation and Programming Guide Using the Programmer's Remote | 55
Edit Follow Time
A preset’s Follow Time is the length of time after a preset is activated that the next
preset will automatically activate. Use the follow time property to make presets
automatically step from one to the next.
Press the
FOLLOW button to switch to the Follow Time mode. The center LED on
the station will blink Yellow (the same color as the Scene button on the remote).
Then, enter the number of seconds to set the Follow Time to.
For example, the following sequence sets the preset’s follow time to 30 seconds:
FOLLOW + 30
In the example above, the preset will automatically activate the next preset 30 seconds after this
preset is activated.
Presets can follow each other in a simple sequential manner, or follow times can be combined
with the Loop To Preset property to create loops.
Follow Times can be entered between 0.01 and 86,400 seconds (1/100th of a second to 24
hours).
To remove a follow time from a preset, enter zero (0). For example:
FOLLOW + 0
To clear the follow time of a preset so that the preset will use the default follow time, press:
FOLLOW + CLEAR
When finished setting the Follow Time property of a preset, you can either press ENTER to save
the changes and return to the station’s Idle Mode, or you can press a different property button
(Fade, Follow, Loop, Repeat, etc.) to enter the value of another property.