Interactive Technologies Commander 2000, Owner'S Manual, Page: 30 / 61

30
Controlling Lights (LIGHTS)
X-10 Lamp Modules allow your system to turn lights on and off. X-10 Lamp Modules can
control any incandescent lights that plug into an outlet.
Panel Light Control
The Panel instructs the X-10 Lamp Module to control lights as follows:
■
During a fire alarm, lights turn on and remain on until the security level
changes or after 12 hours with no system status change.
■
During an intrusion alarm, lights blink until the siren time-out ends, then
they remain on steady for up to 12 hours with no system status change.
■
During entry and exit delay time, lights turn on and remain on for 5 minutes.
NOTE: If the system is disarmed during any of the above scenar-
ios, lights controlled by X-10 Lamp Modules turn on steady
and remain on for an additional 5 minutes.
User Light Control
Lights controlled by an X-10 Lamp Module can be turned on or off with the sys-
tem in any security level.
■
To turn controlled lights on or off from the Panel or a
Handheld Touchpad:
Enter ACCESS CODE + 0 , with the Panel in any security level.
or– Enter COMMAND + 0 from the Panel or a touchpad.
The Panel announces, On or Off .
■
To turn controlled lights on or off from a Keychain Touch-
pad:
Press and hold the Light button until the light blinks.
The Panel announces, On or Off . Controlled lights turn on or off, depending
on the current setting.
0
LIGHTS
Technical Manuals Online! - http://www.tech-man.com