33
6.3
How to Tension the Running Belt
When you are walking on the running platform, you can feel a slipping sensation then the belt has stretched and is
slipping across the rollers. The running belt will be stretched over time. This is a normal and common adjustment
on any treadmill. To eliminate this slipping, see the instruction below.
If it is a minor adjustment
1.
Tension both bolts on the rear roller 1/4 turn clockwise.
2.
Try the treadmill at 1.0 km/h speed to check for slipping.
3.
Try the treadmill again to check for slipping
If it is a significant adjustment
1.
Place four pieces of tape, 1,000mm apart on both edges of the running belt.
2.
Tighten the tensioning bolts until the distances between the tapes are increased to 1,005mm.
3.
Try the treadmill again to check for slipping
Note
Make adjustments in 1/4 turn. DO NOT exceed one full turn of the Adjusting Screws. Over tightening the belt can
significantly shorten the belt life.
6.4 Self
Diagnosis
Your Service Representative requires to check accumulated data about the past usage of Intenza 550 series
treadmill, test the function and error message. For these reasons, Intenza 550 series treadmill is equipped with a
service mode and can offer the diagnosis report for easy trouble shooting. Intenza 550Te is designed with build-in
WiFi that enhance on-line service function. On-line service function is a service diagnostic process that can
automatically send out detected error message to Intenza customer service centre. Therefore, please make sure
the Wi-Fi connection is well- connected after assembly. For more information of self diagnosis, please contact your
local dealer or refer to the service manual.
TENSION
TENSIO
