Intellijel Tete, User Manual

Page: 99 / 173

Tête + Tetrapad Manual
Combo Mode SETUP Menu
When in Combo Mode, the Mode SETUP Menu contains
the parameters shown to the right. The configuration of
some parameters affects the availability of other
parameters, as indicated.
To select a parameter ​ for editing, rotate the encoder to
highlight it.
To edit a parameter, ​ press the encoder on the
highlighted parameter to make it available for editing.
Rotate the encoder to select the desired value, and
press the encoder again to apply your change.
Combo Mode SETUP Menu options are:
● Post Record: ​ (Play, Overdub)
Overdub ​ : When the Looper transitions out of its record state and into playback (for
example by pressing the ​ PLAY ( ) ​ button to end a recording), this choice tells Tête to
immediately enter Overdub mode.
Play ​ : When the Looper transitions out of its record state and into playback (for
example, by pressing the ​ PLAY ( ) ​ button to end recording), this choice tells Tête to
immediately begin playing the loop without enabling overdub capability.
● Record Wait: ​ (Off, Touch)
Touch ​ : Pressing the Record button record-enables Tête, but recording does not
actually begin until you touch a pad. If ​ Looper Sync ​ is set to O ​ n
​
, then you must be
touching a pad at the start of a loop cycle in order to record.
Off ​ : Pressing the Record button causes Tête to immediately begin recording, whether
you touch a pad or not. If ​ Looper Sync ​ is set to ​ On ​ , then recording begins at the start
of the next loop cycle. This lets you synchronize recording to a tempo (either internal or
external).
Page 98