Intellijel Tete, User Manual

Page: 92 / 173

Tête + Tetrapad Manual
Random Voltage Assignment
You can randomize a single output voltage in a bank; all output voltages in a bank; or all output
voltages for all banks. Specifically:
To randomize a single output voltage in a bank:
1. Touch one of the 8, 12 or 16 virtual pads (banks).
2. Push the red SHIFT button and hold it down. While holding the SHIFT button down, press one
of the four encoders.
This generates a random voltage out the corresponding output.
If the SHIFT LED is ​ green ​ , pressing the four encoders randomizes the voltages sent to
Outputs 1-4. If the SHIFT LED is
​
red
​
, pressing the four encoders randomizes the voltages sent
to Outputs 5-8. Pressing the red SHIFT button toggles between these two states.
To randomize all output voltages in a bank:
1. Touch a virtual pad and keep your finger on the desired pad (bank).
2. Press the red SHIFT button.
All eight output voltages (the entire bank) are simultaneously randomized for that pad.
To randomize all output voltage for all banks:
1. Hold the red SHIFT button down and short-press (<1 sec) the white EDIT button.
Every bank is randomized. That is, all output voltages are randomized for every virtual pad.
NOTE: You can also randomize all output voltages for all pads by selecting the “Randomize
Banks” option in the Mode Setup menu for Voltages Mode.
To clear all output voltages for all banks (resetting all voltages to 0V):
1. Hold the red SHIFT button down and long-press (>1 sec) the white EDIT button.
Every output voltage for every bank is set to 0V.
NOTE: You can also clear all output voltages by selecting the “Clear Banks” option in the
Mode Setup menu for Voltages Mode.
Page 91