Intellijel Tete, User Manual

Page: 80 / 173

Tête + Tetrapad Manual
Slew Between Chords
Tetrapad gives you the ability to slew between chord changes. To do so, press the red SHIFT
button and continue holding it while turning Encoder 1.
Clockwise turns increase the time it takes to move from one chord to another (up to approximately
a 4 second glide). Counterclockwise turns decrease the amount of time it takes to move from one
chord to another (down to “instantaneous”).
Slew times are indicated by a red Pad Status LED above each fader — with an LED glowing
increasingly brighter as the slew gets longer.
Note that slew time is a global setting within Chord Mode, meaning the rate of change affects all
chords equally.
NOTE: CV control over slew time is available in Tête’s
​
CV Setup Menu
​
. You can limit the extent to
which CV can control Slew by holding down the red SHIFT button while pressing & turning any of
the four Encoders. Counterclockwise turns set the lower CV-able Slew limit, while clockwise turns
set the upper CV-able Slew limit.
Copying & Pasting Chords
You can copy one pad’s chord assignment to another pad. To do so:
1. Touch ​ and hold
​
the virtual pad that corresponds to the chord you want to ​ copy
​
.
2. With your finger still on the pad, press Tetrapad’s white EDIT button.
That pad’s chord will be copied into temporary memory.
Tête’s screen inverts (white background) and the Chord Name Indicator says “
​
Copy Pad
​
”.
3. Lift your finger from the virtual pad you just copied.
4. Touch
​
and release
​
the virtual pad onto which you want to
​
paste
​
the copied chord.
The chord will be copied to the new virtual pad.
5. If you want the chord pasted to more than one virtual pad, simply touch the additional pads.
The chord will be copied to each pad you touch.
6. Press Tetrapad’s white EDIT button.
Tête’s screen reverts to normal (black background), and normal functions are resumed.
Page 79