Intellijel Tete, User Manual

Page: 155 / 173

Tête + Tetrapad Manual
Overwriting Sequences
You can overwrite steps in an existing sequence. To do so:
1. If the sequence is currently playing back, press the ​ PLAY ( ) ​ button to stop playback.
2. Press the
​
RECORD ( )
​
button.
The cursor in the piano/voltage roll moves to the end of the existing sequence.
3. Press the ​ LOOPY ( ) ​ button.
The Encoder Bar will read ​ Overwrite Mode ​ .
4. Rotate the Encoder to move the cursor around inside the existing sequence.
NOTE: If you move the cursor to the end of the sequence, you’ll exit Overwrite Mode, and be
back in Append Mode.
5. When the cursor is over the step you want to overwrite, press the pad corresponding to the
new value you want.
6. Additionally, you can press Tête’s Encoder, then rotate to change the step’s gate parameters.
For voltages, this means deciding whether to add a gate action or not.
For notes, it means deciding whether to add a rest, a tie/slur, or a note with a gate value of
25%, 50%, or 75%.
7. Press the Encoder to toggle between using it to scroll through the sequence, or using it to
define gate parameters.
8. To DELETE a step, simply press-and-hold the Encoder over the step you want deleted.
Inserting Into Sequences
You can insert steps into an existing sequence. To do so:
1. If the sequence is currently playing back, press the ​ PLAY ( ) ​ button to stop playback.
2. Press the ​ RECORD ( ) ​ button.
The cursor in the piano/voltage roll moves to the end of the existing sequence.
3. Press the ​ LOOPY ( ) ​ button.
The Encoder Bar will read ​ Overwrite Mode ​ .
4. Press the ​ LOOPY ( ) ​ button again.
The Encoder bar will read
​
Insert
​
, and the cursor will show where, exactly the note will be
inserted.
Page 154