/
Steppy 3U Manual
Front Panel
Inputs & Outputs
A. OUT A
- Gate output (+5V) for Track A.
Corresponding LED lights when gate is high.
B. OUT B
- Gate output for Track B. Corresponding
LED lights when gate is high.
C. OUT C
- Gate output for Track C. Corresponding
LED lights when gate is high.
D. OUT D
- Gate output for Track D. Corresponding
LED lights when gate is high.
E. CLOCK (CLK) IN
- Connect an external clock (or
any other trigger source) to this input. Each time
the Clock input voltage goes high, the sequence
advances one step (unless you’re using the built-in
clock divider). The corresponding LED lights every
time it detects an input pulse. Note that Steppy will
not play without a CLK input.
NOTE: Steppy performs best when driven by a
steady clock signal. Syncopated gate sequences or
random triggers may result in unpredictable gate
lengths, delay settings, swing and ratcheting
patterns, since these are derived from the Clock
input.
F. RESET (RST) IN
- Accepts a trigger or gate, which
Steppy interprets in one of two ways:
●
RESET Mode
: A trigger or gate received at
the RST jack resets all patterns (across all
four tracks) back to their first step. This is
particularly useful if your tracks have
different lengths and you wish to re-align
them to their first beats. This is the default
mode, as shipped from the factory.
Page 9