Intelligent Appliance IA-3178-U2i, User Manual

Page: 28 / 39

IA-3178-U2i
28
www.intelligent-appliance.com Specifications are subject to change without notice
32-ch Relay
USB or RS-232 Controlled
!aa51dd – Set device mode Register #51 value
Description
This command changes relay operation mode and enables/disables WD2.
Note

One must set the device mode register #50 value to ‘82’ to enable setting of device mode
register #51 value.

Make sure setting mode register #50 value to its normal setting when done.

See Relay Single / Pair operation Layout to better understand Relay operation options.

The relays may be operated as Single relay or as a Relay Pair.
Syntax !aa51dd <CR>
!
Delimiter character
aa Hexadecimal address of the device
51 System mode command
dd Mode register #51
bit Value (dd) Function
Relays – Single/Pair operation
4
10 1 16 Pairs
00 0 32 Single relays
Relays – Crossing/Following Orientation:
3
08 1 Crossing Pair (!aa5118)
00 0 Following Pair (!aa5110)
WD2 - Host communication watchdog:
2
04 1 Enabled
00 0 Disabled
<CR>
Carriage Return - End of command
Response |dd EE OK if the command was valid
Example 1 Command: !005110<CR>
Response: |10 EE OK
This command will set 16 pairs of “Following Relay” operation.
Operation of pair #1, !00300<CR>, will activate relay #1 and #2.
Operation of pair #2, !00301<CR>, will activate relay #3 and #4.
Last pair is #16, !0030F<CR>, will activate relay #31 and #32.