Cedar 880AG Enterprise Dual-Radio AP/Bridge
•
Aging
time
: Number of seconds remaining before this entry is removed due to
inactivity
5.2.3 DHCP
If DHCP is not available in your network, Cedar can be configured to assign dynamic IP
addresses to computers on the network. Select
Network>DHCP
to perform this function.
DHCP Setting
On
: Enable DHCP service.
Off
: (default) Disable DHCP service.
Pool Status
The pool status should be turned on to enable DHCP service.
Net
Specify the subnet where you want the DHCP to be enabled, for example,
192.168.1.0.
Netmask
Specify the network mask for the subnet.
Range
Enter a range of IP addresses which are to be allocated for dynamic IP addresses
only. Each time a DHCP request comes in; the DHCP server assigns an IP address
from this range to its users.
33