Cedar 880AG Enterprise Dual-Radio AP/Bridge
Figure 3.2 Scan Tool Configure IP Screen
6.
The administrator can assign a static IP address to the AP by :
a)
Change IP address mode to static
b)
Enter IP address, subnet mask and gateway IP address.
c)
Provide the SNMP read/write community name in order to make any
configuration change. The Cedar initial SNMP read/write community name is
private
.
7.
You can also use Scan Tool to upgrade the AP firmware by clicking the
Upgrade
tab:
a)
Select either FTP or TFTP protocol.
b)
Enter server IP address, firmware name and optional FTP login name and
password.
c)
Provide the SNMP read/write community name. The Cedar initial SNMP
read/write community name is
private
.
8.
In case SNMP, telnet or web interface are accidentally turned off, Scan Tool can be
used to turn them back on again by clicking the
Advanced
tab.
)
Intelicis Scan Tool scans Intelicis access points only. It does not scan access points
from other manufactures.
)
Please run one instance of Scan Tool on a network. Running multiple instances may
receive incorrect scan result.
3.2 Default
Setting
Table 3.1 lists Cedar’s manufacturer default settings:
Default login name
admin
Default login password
changeitnow
Default enable password
changeitnow
Default IP address
Acquired from the DHCP server.
Default subnet mask
Acquired from the DHCP server.
Default gateway
Acquired from the DHCP server.
Default DNS IP address
Acquired from the DHCP server
Default management VLAN ID
Untagged
17