8
3. Tear the rubber film on the back of the sensor and pass the wires through the hole;
Do not remove the rubber film it is the guarantee of sealing
against water and insects.
4. Mount the sensor on the wall.
5. Connect the wires to the terminal according to the figure on the terminal block.
3.2. Pole installation
1. Pass the wires through the hole and then pull them out;
2. Remove the cover;
3. Attach the base to the support as shown in the figure below. The base of this sensor
has a suitable design for connection
to a pole.
Note:
M4 × 25 perforating screw.