12000 Series Switches
True Scale Fabric Switches 12000 Series Hardware
Installation Guide
July 2015
54
Order Number: G91928004US
3. When the system displays
image1
or
image2
, press the SPACEBAR to interrupt
the auto load sequence before the counter expires (within 5 seconds).
4. At the
[boot]:
prompt type the following:
moduleip <NEW IP ADDRESS>
and press ENTER.
Note:
For versions previous to 5.0.2, use the command
spineip
.
Note:
The
moduleip
command changes the IP address for
image1
and
image2
on each
module.
5. At the
[boot]:
prompt type
reboot
, and press ENTER. Following the reboot, the
IP address is changed. Repeat these steps for the second management module.
2.9.5
Enabling 8X Ports
Users can enable 8X (10Gbps) ports by combining two (2) 4X ports together (also
known as a “DUO”). The first port in a DUO is known as the master port; the second
port is the partner or slave port. The following CLI commands can enable 8x ports:
•
ismPortSetWidth
: sets the supported link width for an individual IB port.
•
ismChassisSetWidth
: sets the supported link width for all chassis IB ports.
•
ismIslSetWidth
: sets the supported link width for all ISL IB ports. This
command is only available 12800-series switches.
Note:
This section focuses on enabling 8x external cable ports. For details on each command,
refer the
Intel
®
True Scale 12000 CLI Reference Guide
.
2.9.5.1
Creating an 8x Port: 12200/12300
Note:
This section focuses on enabling 8x ports for 12200/12300 switches with an installed
management card. For information on creating an 8x port on an externally-managed
12200, see
“Creating an 8x Port: Externally-managed 12200” on page 57
For the 12200 and 12300 switches, 8x DUOs are set up by combining the 4X port on
the bottom row with the 4X port directly above it (for example, port 1 with port 19, port
2, port 3 with port 21, etc.):
