Intel® Server Platforms SR6850HW4 and SR6850HW4/M Product Guide
5
Safety Information
WARNINGS
Before working with your server product, whether you are using this guide or
any other resource as a reference, pay close attention to the safety instructions.
You must adhere to the assembly instructions in this guide to ensure and
maintain compliance with existing product certifications and approvals. Use
only the described, regulated components specified in this guide. Use of other
products / components will void the UL listing and other regulatory approvals of
the product and will most likely result in noncompliance with product
regulations in the region(s) in which the product is sold.
Emissions Disclaimer
To ensure EMC compliance with your local regional rules and regulations, the final
configuration of your end system product may require additional EMC compliance
testing. For more information, contact your local Intel Representative.
Regulatory and Integration Information
” for product Safety and EMC
regulatory compliance information. This is an FCC Class A device. Integration of it
into a Class B chassis does not result in a Class B device.
Intended Uses
This product was evaluated as Information Technology Equipment (ITE), which may
be installed in offices, schools, computer rooms, and similar commercial type
locations. The suitability of this product for other product categories and
environments (such as: medical, industrial, telecommunications, NEBS, residential,
alarm systems, test equipment, etc.), other than an ITE application, may require
further evaluation.
EMC Testing
If the server board set is to be integrated into a non-Intel chassis, make sure that the
chassis, power supply, and other modules have passed EMC testing using the server
board set with a microprocessor from the same family (or higher) and operating at the
same (or higher) speed as the microprocessor used on this server board.
System power on/off:
The power button DOES NOT turn off the system AC
power. To remove power from system, you must unplug all AC power cords from the
wall outlet. Make sure all AC power cords are unplugged before you open the
chassis, add, or remove any components.
Hazardous conditions, devices and cables:
Hazardous electrical conditions
may be present on power, telephone, and communication cables. Turn off the server
and disconnect the power cord, telecommunications systems, networks, and modems
attached to the server before opening it. Otherwise, personal injury or equipment
damage can result.
