153
TP01582
C
D
A
B
Figure 73. Installing a PCI Card
CAUTION
Some accessory/option board outputs exceed Class 2 or limited power source
limits and must use appropriate interconnecting cabling in accordance with
the national electrical code during installation.
10.
Move the retention latch at the rear of the card slot into the closed position.
11.
Connect any required cabling to the PCI add-in board.
12.
If using the operating system hot-plug interface:
Wait for the software user interface to appear on your monitor and then confirm the device
to be enabled.
Wait for the power LED to turn on.
If using the hardware hot-plug interface:
Press the attention button for the slot. If you need to abort the hot-plug operation, press the
attention button again within five seconds.
Wait for power LED to turn on.
NOTE
For either the operating system interface or the hardware hot-plug interface,
if the attention LED is blinking, a power fault has occurred. You may need to
remove the adapter, wait for the LED to turn off, and re-start the hot
insertion.
