Intel SR2612UR - Server System - 0 MB RAM, Service Manual

Page: 53 / 162

Intel
®
Server System SR2612UR Service Guide 39
Note: The dual 2.5-m power cords included with the Intel
®
Server System SR2612UR have
domestic North American NEMA 5-15 plugs. If required, you can obtain International
power cords locally (for example, via the Internet at
http://www.interpowers.com ).
Figure 29. Powering-On
2. Press the Master Power Switch to power on the unit.
Note: Note: On power up the internal server board on the Intel
®
Server System SR2612UR may
take a couple of minutes to complete initialization and operating system boot activities.
The installation is complete. You can begin using your Intel
®
Server System SR2612UR.
Installing a 2.5-inch Internal Drive
The Intel
®
Server System SR2612UR supports up to two (2) internal 2.5-inch SATA
drives. They are connected directly to the CPU server board and provide the capability to
run the operating system from these drives.
Complete the following steps to install one or more 2.5-inch internal drives in the Intel
®
Server System SR2612UR. For a list of supported drives, contact your Intel sales
representative.
1. Ensure the AC power cord(s) are disconnected from the enclosure.
2. Remove the top cover from the enclosure by loosening the captive screw with a
Phillips screwdriver on the right-rear of the enclosure.
3. Slide the top cover back and lift it from the enclosure.
4. Locate the 2.5-inch drive sled as shown.