Intel SR1690WB - Server System - 0 MB RAM, Service Manual

Page: 44 / 154

26 Intel
®
Server System SR1690WB Service Guide
4. Slide the cover back until it stops and then lift the cover upward to remove it. See
letter “C”.
Figure 13. Removing the Server System Cover
Installing the System Cover
1. Observe the safety and ESD precautions at the beginning of this book. See “Safety
Information” .
2. Place the cover over the server system so that the side edges of the cover sit just
inside the server system sidewalls. Slide the cover forward (see letter “A” in
Figure 14 ).
3. Tighten the screw at the rear of the server (see letter “B”) and install the two screws
at the front of the server (see letter “C”).
Optical
Device
C
A
B
AF003222