Intel Server Board SE7501BR2
Installation and Integration Guide
Installing the Processor Wind Tunnel
The following instructions apply to the base Intel Server Chassis SC5200 and reference
chassis installations. If you are installing your server board in the Intel SC5200 Server
Chassis, Hot-Swap Redundant Power version,
do not
install the processor wind tunnel. The
ducting in this Server Chassis eliminates the need for a processor wind tunnel.
Direct the airflow from the processor wind tunnel toward the rear of the chassis as shown.
Attaching the Heat Sink Fan
Install the processor wind tunnel center section over the
heat sink. The plastic tabs on the wind tunnel center
section must engage the tabs on the retention
mechanism. Make sure the fan’s sticker is facing away
from the assembly, so that the airflow is into the
assembly.
Attaching the Fan/Intake Assembly
1.
Position the fan/intake assembly at approximately 4
and engage the clip at the top of the tunnel as shown.
Gently sq
5°,
2.
ueeze the two tabs on the intake, and insert
3.
ating
it into the two mating slots on the wind tunnel.
Rotate the fan/intake downward to engage the m
clips on the wind tunnel.
16
