Intel SBCEFCSW, Installation Manual

Page: 28 / 62

14
Intel® Server Switch Module SBCEFCSW: Installation Guide
15. Replace the acoustic attenuation module, if you removed it in Step 2
16. Continue with Chapter 3, “Information panel LEDs and external Fibre Channel ports,” on page 17.
Removing or replacing a switch module
xx
CAUTION:
Never remove the cover on a power supply or any part that has the following label attached.
xx
CAUTION:
Hazardous voltage, current, and energy levels are present inside any component that has this
label attached. There are no serviceable parts inside these components. If you suspect a
problem with one of these parts, contact a service technician.
Complete the following steps to replace a switch module:
1. Review the information in “Safety and regulatory information” on page v
and
“Installation guidelines” on
page 10
through
“Handling static-sensitive devices” on page 10
2. Remove the acoustic attenuation module, if any, from the rear of the
SBCE
unit.
3. Remove the LC-LC fiber-optic cables from the two external ports on the SFP module. Removing these
cables will disrupt the network connection from the external Fibre Channel port to any connected external
Fibre Channel devices. For removal instructions, see the documentation that comes with your cable
options.
4. Remove any SFP modules from the switch module external Fibre Channel ports. For SFP module removal
instructions, see the documentation that comes with your SFP module.
5. Pull the release latch toward the bottom of the switch module, as shown in Figure 5. The module moves
out of the bay approximately 0.64 cm (0.25 inch).