Intel® Server System R2600SR Setup and Service Guide
31
Note: Use only an appropriate TIM when replacing the processor such as: PCM45F (70x47x0.25) by
Honeywell International, Inc., Honeywell P/N: 099079. This link provides a demonstration of the application
of the TIM:
https://www.intel.com/content/www/us/en/support/articles/000025195/processors/intel-xeon-
7.
If replacing a heat sink, remove the processor identification label from the old heat sink and place it in
the same location on the new heat sink. The label is on the side of the heat sink closest to the
triangular alignment mark.
8.
If unable to remove the label and place it on the new heat sink or if the label is damaged during
transfer, use a permanent marker to write the processor serial number from the processor
identification label on the new heat sink in the same location as the label would be placed.
3.4.5
Assembling the Processor Heat Sink Module (PHM)
Once the processor and processor clip have been assembled, they can be combined with the heat sink to
create the PHM. Complete the following steps to assemble the PHM.
Figure 130. Assembling a PHM in the shipping tray
Notes:
If replacing a processor, install the heat sink onto the processor and processor clip while the processor and
processor clip are in the shipping tray.
If replacing a heat sink, remove the heat sink from its shipping tray and place the processor and processor
clip in the opposite half of the heat sink shipping tray with the processor contact-side down. To prevent the
processor from falling out of the processor clip, hold the processor clip assembly by its sides with the
processor contact-side up until it is turned over to fit in the shipping tray.
1.
Do one of the following:
a.
Align the triangular marks on the processor carrier and the heat sink or
b.
Align the triangular mark on the processor clip with the notched corner of the heat sink.
2.
Insert the processor clips into the holes on the heat sink.
3.
Press the processor clip into place until the clips at all four corners securely engage.
Summary of Contents for R2600SR Series
Page 2: ...Blank page...
