Intel® Server System R2600SR Setup and Service Guide
29
1.
With the heat sink facing down, place the PHM onto a flat non-conductive surface.
2.
Press the retaining clip at the corner of the processor clip (see Numbers 1, 3, 4 and 5) closest to the
pry point (see Number 2) to release it.
3.
Insert the head of a flat head screw driver in-between the heat sink and the processor clip assembly
(see Number 2) and gently twist until the bond between the heat sink and the processor is broken.
4.
Release the remaining retaining clips.
5.
Lift the processor and retainer straight up and away from the heat sink (see Number 6).
3.4.3
Separating the Processor from the Processor Clip
If the heat sink is being replaced, replace the processor clip. Follow these steps to remove the processor
from the processor clip.
Figure 22. Separating the processor from the processor clip
1.
With the processor contact-side up, flex the ends of the processor clip down and away from the
processor to release the retaining clips (see Number 1).
2.
Remove the processor from the processor clip (see Number 2).
3.
Discard the old processor clip.
Summary of Contents for R2600SR Series
Page 2: ...Blank page...
