Intel® Server System R2600SR Setup and Service Guide
28
Figure 20. Removing a PHM
1.
Fully loosen the Torx T30 captive fasteners on the PHM in the removal sequence shown on the
heat sink label (see Numbers 1-4).
2.
Lift the PHM straight up and away from the processor socket.
Note: Each processor socket must always contains a socket cover or a PHM. When removing or installing a
PHM, protect empty processor sockets with a socket covers. Do not touch the processor socket or contacts
as they are fragile and easily damaged. Contaminants such as oil from skin can cause connection failures.
Remove and install only one PHM at a time. If the system board supports multiple processors, start with the
first processor socket.
3.4.2
Separating the Processor and Processor Clip from the Heat Sink
Once the PHM has been removed from the server board, the processor can be removed from the PHM.
Follow these steps to remove the processor.
Figure 21. Separating the processor and carrier from the heat sink
Summary of Contents for R2600SR Series
Page 2: ...Blank page...
