Intel
®
Server System R2000WT Product Family System Integration and Service Guide
51
3.3
Power Cord Retention Strap Installation
Figure 65. Power Cord Retention Strap Installation
•
Locate the power cord retention strap from the system accessory kit
•
Insert the locking tab end of the Retention Strap into the receiver hole located beneath the power cord
receptical on the back of the power supply module (see letter ‘A’)
•
While pushing up the locking tab on the bottom of the slider, adjust the slider to the desired position (see
letter ‘B’)
•
Install the power cord into the power cord receptical on the back side of the power supply (see letter ‘C’)
•
Pull the slider strap over the power cord and lock it securely into place (see letter ‘D’)
To remove the power cord from the Retention Strap
•
Push down on the slider tab to release the slider strap
•
Pull the slider strap back over the power cord
•
Remove power cord
Retention Strap
Receiver Hole
