Intel
®
Server System R2000WT Product Family System Integration and Service Guide
49
3.1.2
Slimline Optical Drive Removal
NOTE:
The slimline optical drive is NOT hot-swappable. Before removing or replacing the drive, you must first
take the server out of service, turn off all peripheral devices connected to the system, turn off the system by
pressing the power button, and unplugging the power cord from the system or wall outlet.
To maintain proper system cooling, a filler panel must be installed if you do not install a device at this
location
Figure 62. Removing the Slimline Optical Drive
•
Remove the system cover – See section 2.2.1
•
Detach the SATA and Power cables from the back of the optical drive (see letter ‘A’)
•
Detach the optical drive from the drive bay by carefully lifting up on the blue release tab located on the
back of the optical drive (see letter ‘B’)
•
Slide the optical drive out of the drive bay (see letter ‘C’)
•
If no device will be installed in this location, install the supplied filler panel in this location
