Intel® Server System R2000WF Product Family Technical Product Specification
113
Figure 82. Left and right views of riser card #2 and #3 bracket
Depending on the riser card option installed, riser slots #1 and #2 can each support up to two full height, full
length add-in cards (top and middle slots on each riser) and one full height, half-length add-in card (bottom
slot on each riser).
Note
: Add-in cards that exceed the PCI specification for half-length PCI add-in cards (167.65 mm or 6.6 in)
may interfere with other installed devices on the server board when installed in the bottom add-in card slot.
Two card guide brackets on the air duct provide support for full height/full length add-in cards when
installed in either the middle or top add-in card slots of each installed riser card assembly.
When installed, riser slot #3 can support up to two low profile add-in cards. To avoid possible add-in card
bracket interference when installing add-in cards into both riser card #2 and riser card #3, add-in cards in
riser #2 should be installed before those to be installed in riser #3.
Installation of each riser card assembly into the chassis is tool-less. Hooks on the back edge of the riser card
assembly are aligned with slots on the chassis, then each assembly is pushed down into the respective riser
card slots on the server board.
Figure 83. Full height/full length add-in card support
Summary of Contents for R2000WF series
Page 2: ...Blank page...