Hardware Installations and Upgrades
Figure 71. Installing the Server Board
3.
Connect all power cables to the server board.
Replacing the Backup Battery
The lithium battery on the server board powers the RTC for up to 10 years in the absence of power.
When the battery starts to weaken, it loses voltage, and the server settings stored in CMOS RAM in
the RTC (for example, the date and time) may be wrong. Contact your customer service
representative or dealer for a list of approved devices.
Warning:
Danger of explosion if battery is incorrectly replaced. Replace only with the same or
equivalent type recommended by the equipment manufacturer. Discard used batteries according to
manufacturer's instructions.
Advarsel:
Lithiumbatteri - Eksplosionsfare ved fejlagtig håndtering. Udskiftning må kun ske med
batteri af samme fabrikat og type. Levér det brugte batteri tilbage til leverandøren.
Advarsel:
Lithiumbatteri - Eksplosjonsfare. Ved utskifting benyttes kun batteri som anbefalt av
apparatfabrikanten. Brukt batteri returneres apparatleverandøren.
Varning:
Explosionsfara vid felaktigt batteribyte. Använd samma batterityp eller en ekvivalent typ
som rekommenderas av apparattillverkaren. Kassera använt batteri enligt fabrikantens instruktion.
Varoitus:
Paristo voi räjähtää, jos se on virheellisesti asennettu. Vaihda paristo ainoastaan
laitevalmistajan suosittelemaan tyyppiin. Hävitä käytetty paristo valmistajan ohjeiden mukaisesti.
1.
Ensure the AC power cord(s) are disconnected from the system.
2.
Remove the system cover. For instructions, see
3.
Remove the power supply modules. For instructions, see
Removing the Power Supply
Module(s)
.
4.
Remove the PCI riser assemblies. For instructions, see
Removing the PCI Riser Assembly
5.
Remove the air duct. For instructions, see
6.
Locate the battery on the server board.
7.
Gently press the metal clip as shown to release the battery (see letter
A
).
8.
Remove the battery from the plastic socket (see letter
B
).
46
Intel
®
Server System R2000LH2/LT2 Service Guide
