Hardware Installations and Upgrades
Removing the Intel
®
RMM4 Lite
Pull up the RMM4 Lite module to remove it from the mother board.
Removing the Intel
®
RMM4 NIC
1.
Remove the cable to the module (see letter
A
).
2.
Remove the two screws as shown and remove the module out of the server system (see letter
B
).
3.
Remove the cable to the server board (see letter
C
).
Figure 65. Removing the Intel
®
RMM4 NIC
Installing and Removing an Internal Solid State Drive
Before installing or removing the Solid State Drive, please make sure following steps are performed.
1.
Ensure the AC power cord(s) are disconnected from the system.
2.
Remove the system cover. For instructions, see
3.
Remove the rack handles. For instructions, see
4.
Slide the front end module in forward a bit. For instructions, see
Installing a Solid State Drive
1.
Remove the two screws to release the Solid State Drive carrier (see letter
A
)
2.
Place the Solid State Drive in the carrier (see letter
B
).
3.
Secure the Solid State Drive with the four screws (see letter
C
).
4.
Slide the Solid State Drive carrier into the chassis (see letter
D
).
5.
Secure the Solid State Drive carrier with the two screws (see letter
E
).
6.
Connect cables (see letter
F
).
Intel
®
Server System R2000LH2/LT2 Service Guide
41
